Powerfix PBUH 1.5 A1 Uživatelský manuál stáhnout pdf (Strana 32)

PBUH 1.5 A1

Measurement of constructional material or wood moisture

♦ Switch the appliance on by pressing the ON/SET button.

♦ Before taking the ﬁ rst measurement, check that the appliance is functioning

correctly. For this, use the test aid

. On the test aid there are four

measurement points marked as and .

♦ Press the measuring pins on the measurement points . All measurement

lines on the display

begin to blink.

♦ Now press the measuring pins on the measurement points . The measuring

lines on the display

should now be showing 19% (+/- 1%).

♦ When you arrive at the given value in both tests, the appliance is ready for use.

♦ Press the measuring pins into the material to be tested. The measurement

lines on the display

show the moisture content.

♦ To read the result for ﬁ rewood, cardboard and construction timber, use the

left scale with the symbol .

♦ To read the results for mortar, concrete and plaster, use the right scale with

the symbol

♦ If the measured value exceeds the maximum values of 2% resp. 44%, the

measurement lines start to blink.

♦ To minimise measurement errors, carry out comparative measurements at

several locations.

Temperature Display

♦ The temperature is indicated at the top of the display .

♦ Press and hold the ON/SET button for 3 seconds to toggle between

Celsius and Fahrenheit.

Pocket lamp

♦ Press and hold the button for 3 seconds to switch the LED on.

♦ Press the button once again to switch the LED oﬀ .

Automatic switch-oﬀ

The appliance switches itself oﬀ automatically after approx. 30 seconds without

button activation. The automatic switch oﬀ is disabled when the LED

switched on.

Buch_75094_LB2.indb 29 14.06.12 15:55

1 2 ... 27 28 29 30 31 32 33 34 35 36

Žádné komentáře

Powerfix PBUH 1.5 A1 Uživatelský manuál Strana 32